Advertisement
23. Route the bus cable forward to the right front
console frame along the vehicle harness.
24. Route the bus cable connector to the dashboard
and out through the dash opening.
DASH OPENING
25. Measure 300 mm from the end of the bus cable
connector, then secure the bus cable to the
vehicle harness with three wire ties.
BUS CABLE
CONNECTOR
WIRE TIES
© 2009 American Honda Motor Co., Inc. - All Rights Reserved.
DASH OPENING
VEHICLE
HARNESS
BUS CABLE
300 mm
26. Secure the bus cable to the vehicle harness with
five wire ties.
27. Using isopropyl alcohol on a shop towel, clean the
area where the cushion tape will attach. Attach the
bus cable to the floor panel with the two cushion
tapes in the area shown.
VEHICLE
HARNESS
With the vehicle bracket
Using the isopropyl alcohol on a shop towel, clean
the inside of the vehicle bracket where the
cushion tape attaches. Attach the cushion tape on
the vehicle bracket at the location shown.
CUSHION
TAPE
AII 42446 (0908)
WIRE TIES
BUS CABLE
CUSHION
TAPES
VEHICLE
BRACKET
ATTACHMENT
LOCATION
BUS CABLE
7 of 11
Advertisement
