Table of Contents
Advertisement
Turn the knob to select the desired drying time. Confirm it
by pressing the knob.
Set dryness level, if needed
If you want to change the dryness level, make sure that the
Dryness level button « lights up.
Turn the knob to select the desired dryness level, then press
the knob to confirm.
Select options, if needed
If you want to select additional options, make sure that the
Options button « lights up. The options which are selectable
for your programme are indicated by lighting arrows.
Turn the knob to select the desired options. The symbol of
the selected option will blink. To confirm it, press the knob.
Some options / functions can be selected by directly
pressing the button.
Refer to section OPTIONS, FUNCTIONS AND
INDICATORS for more information.
INDIVIDUAL MODE
After you have switched on the dryer, you are not forced to
follow the GUIDED MODE.
It is up to you which order you choose to set your
programme. To do a setting, first press the relevant button,
then turn the knob to select, and finally press the knob to
confirm.
The variety of options and dryness levels depends on the
programme selected. Therefore it is recommended to start
your setting with selecting the programme.
5.
START PROGRAMME
Press and hold Start/Pause « until the button lights up
solidly; the drying process starts.
The duration can be recalculated and adapted in the course
of the programme.
During such phases, an animation occurs on the display.
6.
CHANGE THE SETTINGS OF A RUNNING
PROGRAMME, IF NEEDED
You can still change some settings after a programme was
started:
• Adjust drying time (only if programme Drying time is
selected)
• Add or cancel an option, provided the progress of the
programme still allows it.
Press the relevant button. The selected setting will blink for
a few seconds.
While blinking, you can adjust the setting by turning the
knob. If the value or setting stopped blinking, press the
button again.
Press the knob to confirm the modification. If you do not
confirm, the modification will be confirmed automatically
— the modified setting will stop blinking.
The programme will continue automatically.
To change the settings of a running programme or start
delay, you can also:
• press Start/Pause to put the running programme on pause
• change your settings
• press Start/Pause again to continue the programme.
7.
RESET A RUNNING PROGRAMME, IF NEEDED
Press and hold the On/Off button « until "rES" appears on
the display.
The programme is ended afterwards.
Immediately open the door and unload the laundry, so that
eventual heat in the laundry can dissipate.
8.
SWITCH OFF THE DRYER AFTER PROGRAMME END
At the end of the programme, „End" appears on the
display. Press On/Off « to switch off the dryer. Open the
door and take out your laundry.
The dryer will switch off automatically in about a quarter of
an hour after programme end, to save energy.
9.
EMPTY WATER TANK / CLEAN DOOR FILTER /
CLEAN BOTTOM FILTER
Refer to section CARE AND MAINTENANCE.
EN
3
Advertisement
Table of Contents
