Disassembly Instructions - Mitsubishi Electric MSZ-A09NA Service Manual

9

DISASSEMBLY INSTRUCTIONS

<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are two types ( Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
9-1. MSZ-A09NA MSZ-A12NA MSZ-A15NA
OPERATING PROCEDURE
1. Removing the panel
(1) Remove the horizontal vane.
(2) Remove the screw caps of the panel.
Remove the screws. (See Photo 1.)
(3) Hold the lower part of both ends on the panel and pull it
slightly toward you, and then remove the panel by pushing
it upward.
1Slide the sleeve.
2Pull the terminal while
pushing the locking
lever.
MSZ-A17NA MSY-A15NA MSY-A17NA
Photo 1
Horizontal vane
Photo 2
25
(2) The terminal with this connector has the
locking mechanism.
1Hold the sleeve, and
pull out the terminal
slowly.
Connector
PHOTOS
Screws of the panel
Terminal block
cover
Conduit cover
Screw of the
conduit cover
Conduit plate