Regency L540E Owners & Installation Manual page 24

INSTALLATION
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*For Touch Ups: Satin Black paint is included for burner, and Dark Brown Paint is included for log set,
Note: This Log installation is for NG units only.
1 Rear Centre Log
2 Centre Right Front Angled Log Piece
3 Right Forked Upright Log
4 Left Angled Upright Log
5 Left Angled Cross Log
6 Right Front Angled Log Piece
7 Centre Left Front Angled Log Piece
Rear Log Bracket (540/390 units)
Pilot shield (390 units only)
Lava Rock and Embers
Glass quantities with Log installation
HZI390
HZI540
Note: If glass previously installed - remove 2lbs to equal above quantity.
Ensure unit is cooled to room temperature and remove glass door.
1. HZI390 Unit only.
Remove burner (see manual for instructions).
Remove existing pilot shield by removing 2 screws.
Install pilot shield provided with Log Set using 2 screws from
previous pilot shield. Reinstall burner.
New Pilot Shield - HZI390 Only
2. Both HZI540 & HZI390 Units.
Sweep glass aside (if already installed) to install Rear Log Bracket,
clip the front edge of the rear bracket on to rear of the burner as
shown below.
Rear Log Bracket
24
919-350
HZI390E / HZI540E / HZI390PB / HZI540PB
HZ540E OPTIONAL LOG SET INSTALLATION
OPTIONAL LOG SET INSTALLATION
5 lbs
6 lbs
5
4
3. Place Log 1 on Rear Log Bracket, ensure Log is centered. Place
small amount of glass crystals on pilot cover, over top pilot area in
front of Log 1.
Center Log 1 on bracket
4. Place Log 2 on the glass, angled with the non charred point of the
Log is approximately 9-1/4" from the right side of the burner tray.
1
1
3
7
2
1
1
2
2
9-1/4"
Position Log 2
L540E-2 / HZI540E-2 Direct Vent Gas Insert
6
03/04/14