Table of Contents
Advertisement
Assembly and Use for the 2.1L Pitcher
Assembly
Fig. 1
Fig. 2
IMPORTANT: Make sure that the motor base is
plugged in for use.
1
Place the motor base on a clean, dry, level surface such
as a counter or table top.
2
Align and lower the Pitcher onto the motor base. (Fig. 1)
Handle should be aligned slightly to the right of the
"LOCK" symbol on the motor base.
3
Rotate the pitcher clockwise as far as it will go to lock
in place. (Fig. 2)
4
The pitcher can be placed on the motor base two ways;
the handle can be on the front right corner or the front
left corner. (Fig. 3a, Fig. 3b)
5
Holding the 6-Blade Assembly by the top of the shaft,
place it onto the drive gear inside the pitcher. Ensure
that the attachment is seated properly and is standing
upright. (Fig. 4)
NOTE: The blade will fit loosely on the drive gear.
Fig. 3a
Fig. 3b
6
Add the ingredients to the pitcher, making sure not to
overfill.
NOTE: Do not exceed the highest measured marking
line on the side of the pitcher.
NOTE: If you need to add additional ingredients while
the appliance is blending, open the pour spout cap and
pour the ingredients in through the opening.
7
Plug the power cord into the electrical outlet and press
the power button ( ).
NOTE: As a safety feature, the power
button ( ) will flash and the motor will not work
if the pitcher and lid are not installed correctly.
When the pitcher and lid are installed properly,
the power button ( ) will be solid, indicating that
the appliance is ready for use.
8
Holding the lid by the handle in the upright position, place
it on top of the pitcher aligning the arrow ( ) located on
the lid with the arrow ( ) located on the pitcher's handle.
(Fig. 5) Press the handle down until you hear a click.
Fig. 4
Fig. 5
NZ: 0800 002 999
8
Advertisement
Table of Contents
