Advertisement
5
Electrical connections
5.1
Electrical power supply
For
Warning:
disconnect the power supply cord to
the heater before any service or testing
is performed.
Warning:
This
electrically grounded in accordance
with the most recent edition of the
National Electrical Code. NFPA 70. In
Canada, all electrical wiring to the
heater should be in accordance with
local codes and the Canadian Electrical
Code, CSA C22.1 Part 1. Do not rely
on the gas or water piping to ground the
metal parts of the heater.
The water heater requires an electrical power supply
from a 120VAC / 60Hz circuit (with a dedicated outlet)
and must be properly grounded.
The heater is wired as shown in the wiring diagram of
the water heater installation manual.
Fig. 10 Connecting power supply cord
1
Power cord length: 3ft.
Note: Outlet appliance is plugged in to should be
clear from possible water damage.
Warning: Confirm that the water
heater is appropriately grounded and
that the installation meets all applicable
electrical
codes
installations.
B Refer to water installation manual to complete
installation of gas and water piping connections.
B Start and operate the water heater according to the
water heater installation manual. NOTE: Open the
control panel shield to access the controls of the
heater, see Fig. 3.
6 720 608 835
safety
reasons,
heater
must
be
for
outdoor
Electrical connections
7
Advertisement
