Advertisement
Quick Links
Outdoor Kit Installation Instructions
Aquastar Tankless Water Heater
For Aquastar models: 2400 ES, 2700 ES
Part no. AQOK
Warning: This kit must be installed by a qualified
installer in accordance with these instructions and
all applicable codes and requirements of the
authorities having jurisdiction.
Advertisement
Related Manuals for AquaStar 2400 ES
Summary of Contents for AquaStar 2400 ES
- Page 1 Outdoor Kit Installation Instructions Aquastar Tankless Water Heater For Aquastar models: 2400 ES, 2700 ES Part no. AQOK Warning: This kit must be installed by a qualified installer in accordance with these instructions and all applicable codes and requirements of the...
- Page 2 Warning Warning Danger: The top of the outdoor kit will Warning: Damage to the appliance get very hot during operation. Keep from freezing is not covered under the away from children. Install heater in a manufacturer's warranty. location where the top of the kit cannot be reached by small children.
-
Page 3: Selecting Heater Location
Selecting heater location Selecting heater location Before proceeding, read the water heater installation Best practice note: The clearances in manual. If the information in that manual is not followed Fig. 1 and table 1 are the minimum exactly, a fire, explosion or poisoning by carbon monox- allowed by the standard. - Page 4 Installing outdoor kit Installing outdoor kit Replace the control panel shield B 1. Remove the cover plate (A) installed on the top of the appliance, as shown in Fig. 4. B Loosen the two Philips head screws located on B 2. Attach the supports (B) to the appliance by bottom rear of cover (see Fig.
- Page 5 Installing outdoor kit Fig. 6 B Attach the outdoor vent cap to the appliance by fas- tening the two provided screws and washers, see Fig. 7. Fig. 7 NOTE: Once this kit is installed, the outdoor vent cap will need to be removed before removing the front cover.
-
Page 6: Mounting Instructions
Mounting instructions Mounting instructions B The water heater is approved for installation directly on an outside wall. Secure the wall mounting bracket provided with the water heater to a wall surface. See Fig. 8. B The installation method of the mounting bracket will depend on the type of mounting surface. -
Page 7: Electrical Connections
Electrical connections Electrical connections Electrical power supply safety reasons, Warning: disconnect the power supply cord to the heater before any service or testing is performed. Warning: This heater must electrically grounded in accordance with the most recent edition of the National Electrical Code. - Page 8 Measuring carbon dioxide (CO2) Measuring carbon dioxide (CO B See the water heater installation manual for details on measuring carbon dioxide (CO Warning: Outdoor vent cap will get very hot during operation. B Ensure the vent cap is cool before performing the procedure below.
- Page 9 Notes Notes 6 720 608 835...
- Page 10 Notes 6 720 608 835...
- Page 11 Notes 6 720 608 835...
- Page 12 Replacement Parts available from: BOSCH THERMOTECHNOLOGY CORPORATION Bosch Termotecnologia, S.A. 340 Mad River Park Estrada de Cacia Waitsfield, VT 05673 Tel. 800-642-3111 3801 - 856 Aveiro - PORTUGAL www.boschhotwater.com Recycled paper © 2009 Bosch Thermotechnology Corp., Londonderry, NH...