Product Dimensions - Frigidaire FGDS3065PF Installation Instructions Manual

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

Product dimensions

NOTE:
1. Do not pinch the power supply cord or
the flexible gas conduit between the
range and the wall.
2. Do not seal the range to the side
cabinets.
3. 24" (61 cm) minimum clearance
between the cooktop and the bottom of
the cabinet when the bottom of wood
or metal cabinet is protected by not
less than ¼" (0,64 cm) flame retardant
millboard covered with not less than
No. 28 MSG sheet metal, 0,015" (0,4
mm) stainless steel, 0.024" (0,6 mm)
aluminum, or 0,020" (0,5 mm) copper.
30" (76,2 cm) minimum clearance when
the cabinet is unprotected.
4. For cutouts below 22 7/8" (58,1 cm),
appliance will slightly show out of the
cabinet.
5. Allow at least 19 ¼" (48,9 cm) clearance
for door depth when it is open.
* IMPORTANT:
than 30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening
while pushing into it. Raise leveling legs at a higher position than the cabinet height
(see page 3), insert the appliance in the counter and then level.
is supported by the leveling legs and NOT by the cooktop itself.
IMPORTANT:
Cabinet and countertop
width should match the cutout width.
A. HEIGHT B. WIDTH
(Under Cooktop)
35 7/8" (91,1 cm) 30"
36 5/8" (93 cm) (76,2 cm)
(Models with an Electric Oven and a Gas Cooktop)
To avoid cooktop breakage for cutout width (E dimension) of more
E
E
C. D. TOTAL
COOKTOP DEPTH TO
WIDTH FRONT OF
RANGE
31 1/2" 28 5/16"
(80 cm) (71,9 cm)
21¾"
(55.25 cm)
Door
Open
B
23 1/4" (59,05 cm) max.
FRONT OF
CABINET
E. CUTOUT F. CUTOUT
WIDTH* DEPTH
(Countertop
and cabinet)
30±1/16" 21 3/4" (55,2 cm) Min.
(76,2±0,15 cm) 22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
backguard
4
D
C
A
Side Panel
Make sure the unit
22 7/8" (58,1 cm) min.
(see Note 4)
1 1/8"
(2,86 cm)
F
Ref.
G. HEIGHT
OF COUNTERTOP
35 7/8" (91,1 cm) Min.
36 5/8" (93 cm) Max.