Machine Assembly; Compact Cover - Vitamix Blending Station Advance Use And Care Manual

M AC H I N E ASS E M B LY

Compact Cover

Cover Door:
1. The cover door can be removed by opening it until the door is horizontal.
Then, gently spread the sides of the door over the round hinges and remove.
2. To reinstall the cover door, gently spread the sides of the door and place the
door hinge cutouts over the round hinges.
IMPORTANT NOTES!
Containers:
• The Blending Station® Advance® machines are optimized for use with the
Vitamix® 48 oz. / 1,4 L Advance® container (3 sided container). The 64 oz. / 2,0 L
standard container will not fit in the compact cover used on the Blending Station®
Advance®. Contact Vitamix customer service at (800) 886.5235 or contact your
distributor for more information.
• Outside the United States and Canada, your machine may come with a different
container configuration.
14
FIGURE A
Back Cover:
1. To remove the back cover:
• First remove the cover door from the unit as described above.
• Remove the two back cover mounting screws from the rear
of the machine (see Figure B).
• From the rear of the machine, firmly push the bottom of the cover forward
(towards the control panel), keeping the bottom edge of the cover against the
motor base. DO NOT tilt or strike the cover during removal.
• Slide forward until the side latches on the front of the cover are released
from the motor base (see Figure C). DO NOT strike the cover to "pop" the side
latches from their tracks. Doing so will cause damage. The cover must only
be removed by sliding it forward (towards the control panel).
2. To replace the back cover:
• Place the back cover on the motor base approximately 1 inch / 2,4 cm
forward of its normal position.
• Slide the cover towards the back of the machine (away from the control panel).
Make sure the side latches slide into their tracks.
• Push until back of cover is seated against the motor base (see Figure D).
Make sure the back cover is fully seated in the back and the side latches
are in their grooves before inserting and tightening the mounting screws.
• Replace and firmly hand-tighten the two back cover mounting screws
(see Figure B). DO NOT over-tighten or use any tools to tighten.
DO NOT use the mounting screws to pull the back cover into position.
Doing so will cause damage.
FIGURE B FIGURE C FIGURE D
15