Nilfisk-Advance City Ranger 2250 Operator's Manual page 14

Operator's manual
Horizontal/vertical hedge trimming on the left side
1. Move the joystick to the right until the cutting bar is
raised in the horizontal/vertical position
or
2. Move the joystick to the left until the cutting bar is
lowered in the horizontal/vertical position
1 1
3. To trim at higher horizontal/vertical positions: Press and
Skid
hold the black button and move the joystick to the right.
The arm moves up. Repeat positions as described in points
1 + 2
4. To trim at lower horizontal/vertical positions: Press and
hold the black button and move the joystick to the left.
The arm moves down. Repeat positions as described in
points 1 + 2
Tips!
Trim hedges and bushes from below, i.e. with the cutting
bar turned with the outer part down, so that the skid just
touches the ground. Start trimming. The cutting bar is
then raised higher up the hedge, so that the same section
is trimmed all the way to the top. (Picture 1)
Operating speed
Depending on the conditions, an operating speed of 1–3
km/h is recommended.
14
Operator's Manual City Ranger 2250 Hedge Trimmer