Setting Trimmer Position - Nilfisk-Advance City Ranger 2250 Operator's Manual

Operator's manual

2.4 Setting trimmer position

Set the trimmer position by moving the joystick to the left
or right, pressing the black button on the joystick at the
same time. (Picture 1)
Hedge trimming on the left of the machine
1. Press and hold the black button and move the joystick to
the right. The arm now moves vertically. (Picture 2)
2. Press and hold the black button and move the joystick
to the left. The arm now moves out to the left. (Picture 3)
3. Move the joystick to the left. The end of the cutting bar
now moves up. (Picture 4)
Horizontal/vertical hedge trimming to the left
1. Move the joystick to the left until the cutting bar is
raised in the horizontal/vertical position
or
2. Move the joystick to the right until the cutting bar is
lowered in the horizontal/vertical position
3. To trim at higher horizontal/vertical positions: Press and
hold the black button and move the joystick to the right.
The arm moves up. Repeat positions as described in points
1 + 2.
4. To trim at lower horizontal/vertical positions: Press and
hold the black button and move the joystick to the left.
The arm moves down. Repeat positions as described in
points 1 + 2.
12
1
Joystick right - left and black button
2
3
1
4
Cutting bar up
Operator's Manual City Ranger 2250 Hedge Trimmer
Arm up
Arm down