Table of Contents
Advertisement
Engine oil filter replacement
with the engine at standstill
1.
Stop engine and disable engine start.
2.
Set three-way cock (2) the position where
both filters are cut-in:
a Both filters cut in (operating posi-
tion)
b Right-hand filter cut out
c Left-hand filter cut out
3.
Turn threaded vent plug (1) counterclock-
wise by one revolution.
Result:
Oil drains from oil filter through the oil
ducts in the engine.
4.
Use torque wrench to tighten threaded vent plug (1) to specified tightening torque.
Name
Threaded vent plug
5.
Remove central screw (1) with sealing
ring (2).
6.
Take off filter bowl (3) with oil filter ele-
ment (4).
7.
Insert new oil filter element (4) in filter
bowl (3) with the front face with coil spring
facing upwards.
8.
Position filter bowl (3) with new O-ring (5)
on filter head.
9.
Tighten central screw (1) with new sealing
ring (2) manually.
10.
Use torque wrench to tighten central screw (1) to specified tightening torque .
Name
Central screw
11.
Replace other oil filters in the same way.
12.
After each oil change and filter replacement, bar engine with starting system (→ Page 73).
13.
Check oil level (→ Page 95).
Size
Type
Tightening torque
Size
Type
Tightening torque
Lubricant
Lubricant
MS15029/01E 2015-06 | Task Description | 101
Value/Standard
25±2 Nm
Value/Standard
40 Nm ±5 Nm
Advertisement
Table of Contents
