Operations; First-Time Startup; Default Parameters - Datalogic AL5010 Product Line Manual

AccuLazr™ AL5010 Product Line Manual

6 Operations

First-time Startup

Default Parameters

06-AL5010_Operations_R20.doc
This chapter provides details on how the AL5010 bar code scanning
solutions function during normal operation. It also outlines how you can verify
optimal performance through several methods:
Become more familiar with your application

Step-by-step start-up operations checklist

Status Indicator LEDs

AL5010 Reader

AL5010 Interface Module

Diagnostics to confirm normal operations

After configuring your AL5010 reader using the browser-based setup
application, use the operations checklist to verify normal operations.
On initial power-up, the AL5010 performs a series of self-diagnostic and LED
tests. The complete power-up sequence takes less than 20 seconds.
When the STATUS LED flashes and turns a steady green the power-up
sequence is complete. The AL5010 is now operational.
NOTE: When an application uses multiple AL5010 readers, you can
provide each reader with a unique reader name using the browser-based
setup application. This makes it easier to keep track of reader parameter
changes when working with several readers on a network. (See Chapter 5.)
The reader is shipped from the factory with these defaults:
Connection Mode: Setup Cable

Reader Name: AL5010

Control Panel Buttons Enabled

Code 128 (10-30 characters)

IP address 192.168.3.100

Perform the following setup procedure using these defaults or configure your
AL5010 with your application's parameters using the browser-based setup
application.
Operations 91
Accu-Sort Systems, Inc.