5. FITTING THE SPARE
WHEEL
-
Position the wheel on the hub and
start tightening the bolts by hand.
-
Carry out an initial tightening of the
bolts using the wheelbrace.
Downloaded from
www.Manualslib.com
-
Lower the vehicle completely by
folding the jack, then remove the
jack.
-
Tighten the bolts again using the
wheelbrace, tighten them fully
without forcing them.
-
Place the wheel to be repaired in
the carrier.
manuals search engine
Changing a wheel
-
Secure the carrier on the hook then
raise the carrier using the bolt and
the wheelbrace.
Never go underneath a vehicle
that is supported only by a jack
(use a ramp). Never use
a screwdriver in place of the
wheelbrace .
7