Configuration By Commands; Client: Adapter Is The Bluetooth Device Which Initiates The Connection - Brainboxes BL-819 Product Manual

Re-boot (power cycle) your adapter. When the Client adapter is switched on, it will connect to the Server device you have
entered in the menu above, assuming of course that the server device is also powered up. Remember of course that the
factory shipped configuration of the adapters is "server" so only 1 device needs any modification in this respect

1.17.3. Configuration by Commands

Access the Adapter you wish to change to "Client" for command mode as documented above and send the following
commands:
padd = 000A-4F-00082D<CR>
svr = 0<CR>
Now power cycle you're Adapter and it will attempt to connect to the server device.

1.18. Client: adapter is the Bluetooth device which initiates the connection

The instructions in the above section for creating a "cable replacement" connection should be followed to place the adapter
into Client Mode in order to initiate a connection to a remote device substituting the address for that of the other device
which you are trying to connect to.
Some remote devices do not allow connection to a Serial Port Profile, but may allow connection to DUN, LAN or FAX profiles.
If this is the case, only the Windows Configuration UI or command mode can be used to change the behaviour of your
Adapter in this respect. This option is documented above in the Adapter configuration section.
Manual for BL-819, BL-830, BL-875
V6.1
Press C to select the client option. This setting is stored
immediately and is not discarded upon a reboot. In
fact it requires a re-boot in order to activate it.
Press "Esc" to skip this option
© Copyright Brainboxes Ltd Page 33 of 40