Electrical And Structural Requirements; How To Assemble Your Floor Fan - Fanimation FP8014 Series Owner's Manual

Electrical and Structural Requirements

ELECTRICAL REQUIREMENTS
Table / Wall fan requires a grounded electrical supply
line of 120 volts AC, 60 Hz, 15 amp circuit. 8 ft power
cord included. NOT for Damp Location Use.
▲WARNING
To Avoid Fire Or Electrical Shock, Do NOT Use This Fan
With Any Solid-State Speed Control Device And Do NOT
Use By Open Window.
1. Assemble the leg to the motor assembly
with 3/16-24 x 12mm screws.
Make sure all screws securing tight the leg
with motor assembly. (Figure 1)
2. You have now completed the assemby of your
fan. Plug cord directly into the socket. (Figure 2)
3. Select the desired airflow, located on back of motor
assembly by rotating switch clockwise. (Figure 3)

How to Assemble Your Floor Fan

▲WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Motor Assembly
HARDWARE USED:
3/16-24 x12mm
SCREWS
4
Leg
Figure 1
x 12
Figure 2
Rotating Switch
Figure 3