Dish Network TR-40CRA User Manual page 35

TR-40CRA D
2 Place the G-LINK wand
approximately one inch in front of
the remote control sensor on your
TR-40CRA converter. Use tape to
secure the G-LINK wand to the TR-
40CRA front panel.
Note: The remote control sensor is
located on the middle of your TR-
40CRA converter's front panel.
Updating TV Guide On Screen
and Guide Plus Setup
After connecting your TR-40CRA converter to your TV Guide On Screen or
Guide Plus-enabled device, use these steps to complete the setup.
Note: The menu options on your Guide-enabled device may differ from the
ones described here.
1 Using the remote control for your Guide-enabled TV, DVD recorder, or
VCR, press GUIDE to open your Guide Listings screen.
2 On the Service Bar, select Setup, then Change System Settings.
3 If available, select No, repeat setup. Otherwise, follow the on-screen
prompts.
Entering Your Location
The Guide uses setup information to provide TV show listings and channel
lineups for your area.
1 Select USA as the country.
2 Use the remote control NUMBER PAD or the UP and DOWN ARROWS to
enter the Substitute ZIP Code for your area. See page 28 for the ZIP code
listing.
Set Up Your TR-40CRA
For your Guide to communicate with your TR-40CRA converter, the Guide must
be set up as though the TR-40CRA converter is a cable box, even though you
do not have cable service. Use these steps to finish setting up your TR-40CRA
converter.
1 Select Cable with a Cable Box or Yes I have cable.
2 If asked, select the type of audio/video input you used to connect your TR-
40CRA to your Guide-enabled device, then follow the on-screen prompts.
- -A
IGITAL TO
TV G O
UIDE
TV C
NALOG
S G
N CREEN OR
G- LINK Wand
IR Sensor IR Sensor
1 inch 1 inch
G- LINK Wand G- LINK Wand
ONVERTER
P S
UIDE LUS ETUP
Page 25