Installation - Dish Network TR-40CRA User Manual

TR-40CRA D
I
NSTALLATION
I
NSTALLATION
Note: These instructions assume you already have an over-the-air antenna
installed. If you need help choosing or installing an over-the-air antenna, refer to
www.antennaweb.org or your local retailer.
Connecting Your TR-40CRA to Your TV
Important Safety Note: Do not connect your TV or your TR-40CRA
converter to a power supply until after you have properly connected all
of the cables using the following instructions.
1 On the back of your TV, locate the A
your TV to your over-the-air antenna. This connection may be labeled
O -
VER THE
your TV's User Guide for help locating this connection.
2 Disconnect the coaxial cable from your TV's A
Note: If your TV uses twin-lead (300 ohm) connections, you will need to
obtain and install a 75 ohm to 300 ohm converter on your TV. This
converter can be found at most consumer electronics stores.
3 Look at the back of the TR-40CRA, and locate the O
I connection (refer to image above). Connect the coaxial cable from
N
step 2 to the O
not use a wrench to tighten this connection.
Note: The TR-40CRA includes only a digital over-the-air tuner. If channels
in your area are still broadcasting analog signals, you can view these
channels by pressing the
40CRA remote, and then changing channels using the TV's remote control.
4 Determine the connection type you'll use to connect your converter to your
TV. The TV S
A
NTENNA
3 or 4 (step 5). Alternatively, if your TV has RCA connectors for audio and
video, you can use RCA cables to connect from the A
connection (RCA-type) on your converter to your TV's video input (go to
step 6).
Page 2
-
IGITAL TO
TR-40CRA Back Panel Connections
-A A I
IR NTENNA N
- -A
VER THE IR
ANALOG PASS-THROUGH
O connection uses a coaxial cable to connect to a TV's
ET UT
I connection, and carries video and mono audio on RF channels
N
-A
NALOG
NTENNA
, C I , C
ABLE N OAX
A I connection on the TR-40CRA. Do
NTENNA N
TV C
ONVERTER
I connection, which connects
N
I , or another name. Refer to
N
I connection.
NTENNA N
-
VER THE
button on the TR-
/V
UDIO
-A A
IR NTENNA
IDEO