Dish Network TR-40CRA User Manual page 30

TR-40CRA D
T
ROUBLESHOOTING
Symptom
You're receiving a
"signal loss"
message on
some or all
channels.
Page 20
- -A
IGITAL TO
1 Try a different channel. Sometimes, just one channel
may be experiencing a problem, while other channels are
fine.
2 Verify that the cable connecting to the O
A I
NTENNA N
to your over-the-air antenna.
3 Verify that your over-the-air antenna is still in place, and
does not appear to have moved. If the antenna is moved
out of alignment, you may receive signal loss messages
on some or all of your channels.
4 Try resetting your TR-40CRA converter. Press the
POWER button on the TR-40CRA remote control to turn
it off, then unplug the your TR-40CRA converter from the
power outlet for 15 seconds, plug it back in, and turn it
back on.
5 Check the signal strength on your over-the-air channels.
Using your TR-40CRA remote control, press MENU,
select Setup, System Setup, Channel Setup, then Add
a New Channel. Find the channel that is experiencing
problems, and verify that it has a strong signal. Channels
with signal strength below 54% will experience loss of
video.
6 Your over-the-air antenna may need to be adjusted.
Contact your local retailer for assistance. If you want to
try adjusting the antenna yourself, refer to
www.antennaweb.org for antenna recommendations and
antenna alignment information.
TV C
NALOG
Troubleshooting Steps
connection is hand tight, and is connecting
ONVERTER
T A
VER HE IR