Dolmar PS-34 Repair Manual page 19

06 Carburetor / intake system
06-02 Installing the carburetor
Position the connecting muff so that it is slightly
tilted to the left so that the back right-hand
double strut of the connecting muff (1) is posi-
tioned behind the plate of the carburetor clip.
4
5
7
06-03 Control side of the carburetor
Unscrew cover (2), remove diaphragm (3)
and gasket (4). Remove screw (5). Remove
the admission needle (6) with spring (7),
arm and axle (8).
06-03 Checking the admission needles
for leaks
Pull fuel line off carburetor nipple and put
on hose of test appliance 944.603.020.
Check that 0.5 bar is maintained over a
minute.
1
2
3
8
6
06-02 Installing the carburetor
Insert the connecting muff with a slight
twist to the right.
12
11
06-03 Pump side of the carburetor
Unscrew cover (9), remove gasket (10)
and diaphragm (11). Clean filter in bottom
of carburetor (12).
15
06-08 Removing the throttle linkage
Remove the handle to the side (14). With
assembly, position the angle of the throttle
linkage (15) behind the plate of the throttle
grip (16). The throttle linkage is inserted in
pockets on the housing floor (17).
9
10
14
16
17
Page 19