Lava Ether-Serial Link Quick Installation Manual page 7

6
Configuring Ether Link network settings using the Ether Link
Manager
To set an Ether Link's network
settings using the Ether Link
Manager , right-click on it in the
Ether Link tree and select
"Properties" . If the Ether Link is
accessible on the network, a
dialog will open that allows you
to give it a new name, IP
address, subnet mask, and
gateway address. If your
network assigns IP addresses
using a DHCP server, DHCP
detection can also be enabled.
The Ether Link Manager can also
auto-configure a link when a
DNS server is used.
Changes made using the Ether
Link Manager will be updated
to both the local PC and to the
Ether Link.
NOTE: Changing the network settings of an Ether Link device may
make that device unavailable to other stations that have activated
a connection to that device using older network settings.
NOTE: The Ether Link Manager is the recommended method of
changing all Ether-Serial Link settings.