Configuring Network Settings - Lava Ether-Serial Link Quick Installation Manual

5
Before Proceeding:
192.168.0.35. If this IP address cannot be used on the network (it may already
in use, for instance), do not initially connect the Ether-Serial Link to the
network. Instead, either:
1) connect the Ether-Serial Link to a network segment that is not already
using the Ether-Serial Link default IP address for another device or,
2) connect the Ether-Serial Link directly to a host PC using an Ethernet
crossover cable.
Follow the procedure described in the "Configuring network settings" section
of this manual to set the IP address to a usable address for the network onto
which the Ether-Serial Link will be installed.
B. Configuring network settings
The Lava Ether Link Manager
Windows Explorer-like interface. Any Lava Ether Links that are
discovered on your network are displayed in the "Ether-Links Near
Me" branch of the "My Ether Link Network" tree.
Ether Link devices installed on your network will need unique IP
addresses.These can be set by using either the
a web browser, or a Telnet client.
The factory default network settings for the Ether-Serial Link are:
IP address:
Subnet mask:
Gateway address: 0.0.0.0
Name:
Workgroup:
DHCP detection:
The Ether-Serial Link is factory preset with an IP address of
displays Ether Link information in a
192.168.0.35
255.255.255.0
[empty]
[empty]
disabled
Ether Link Manager,