Wan Activation - Lava Ether-Serial Link Quick Installation Manual

12
Activating an Ether-Serial Link on a WAN is be done in two
different ways, depending on the network location of the
Serial Link :
• Ether-Serial Link
directly accessible on the Internet.
• Ether-Serial Link
located behind a gateway or router and is not directly
accessible.
Configuration & installation when Ether-Serial Link is external:
NOTE: All steps assume the Ether-Serial Link has already been
configured and is working on a public IP address.
1. Obtain the IP address of the
2. Open the embedded web page of the
your browser by typing in its IP address in the address bar.
3. Ensure that the port(s) to create the WAN activation on are
configured for "Driver Mode".
4. Record the TCP port number of the port(s) to be accessible.
5. Close your browser.
6. Open the LAVA
Activation" button, located on the main toolbar.
7. This will open the "WAN Port Settings" window.
8. Enter the IP address of the
number of the first port you wish to create the WAN activation
on, then click OK.
9. This will create a new COM port that you can configure and
connect to as you would a standard
Verify this by clicking on "My Computer" in the LAVA
Manager.
titled "LAVA Ether-Serial Port (COMXX)" resembling the WAN
activation icon.
E. WAN activation
located externally –
located internally –
Ether Link Manager
In the right hand pane you should find a new port
Ether-Serial Link
Ether-Serial Link
Ether-Serial Link.
Ether-Serial Link
and click on the "WAN
Ether-Serial Link
Ether-Serial Link
Ether-
is
is
from
and the TCP port
COM port.
Ether Link