Extinguishing - Biasi Inovia 25C ERP User Manual And Installation Instructions

with minimum intervals of 15 minutes (Fig.
2.29).
Fig. 2.29
Press key 14 to access the time modifica-
tion, and the digits to be programmed will
begin to flash.
To modify the on and off time, press key 17
or 18.
To confirm the on/off point and move on to
the next point, press key 14 in Fig. 2.28.
If all 4 programmes (P1÷P4) are not used,
the unused programmes must be set to 0 as
shown in Fig. 2.30.
Fig. 2.30
Press key 19 briefly to save the values en-
tered and the display will indicate OK to
confirm.
INSTRUCTIONS FOR USE
Fig. 2.31
To exit programming, hold down key 19 for
5 seconds (all changes will be saved) or
wait 60 seconds.
To reset all the time brackets, please refer
to paragraph 1.3 to page 9.
2.7

Extinguishing

Press the key for 2 seconds 14 (Fig. 2.32)
until the symbol appears on the
display (Fig. 2.33).
11
12
13
14 15
Fig. 2.32
Fig. 2.33
19
18
17
16
- 21 -