Correct Usage - Toshiba RAV-SM563UT-E Owner's Manual

CORRECT USAGE

When you use the air conditioner for the first time or when you change the SET DATA value, follow the
procedure below. From the next time, the operation displayed on the remote controller will start by pushing
ON / OFF
the button only.
Preparation
Turn on the main power switch and/or the leakage breaker.
• When the power supply is turned on, a partition line is displayed on the display part of the remote controller.
After the power supply is turned on, the remote controller does not accept an operation for approx. 1
*
minute, but it is not a failure.
REQUIREMENT
• While using the air conditioner, operate it only with
switch and the leak breaker.
4
1
ON / OFF
Push button.
The operation lamp goes on, and the operation starts.
2
Select an operation mode with the
MODE
"MODE " button.
One push of the button, and the display
changes in the order shown on the right.
• In HEAT mode, if the room temperature reaches to the set temperature, the outdoor unit stops and
the air flow becomes LOW and the air volume decreases.
• In the defrost mode, the fan stops so that cool air is not discharged and PRE-DEF
3
Select air volume with "
One push of the button, and the display
changes in the order shown on the right.
• When air volume is "AUTO
• In DRY mode, "AUTO
• In heating operation, if the room temperature is not heated sufficiently with VOLUME "LOW
tion, select "MED.
4
Determine the set up temperature by pushing the "TEMP.
Stop
ON / OFF
Push button.
The operation lamp goes off, and the operation stops.
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
FAN " button.
", air volume differs according to the room temperature.
" is displayed and the air volume is LOW.
" or "HIGH " operation.
ON / OFF
button without turning off the main power
ON / OFF
FAN MODE
SWING/FIX VENT
UNIT
AUTO HEAT
AUTO
" or "TEMP.
6
1
3
2
DRY COOL FAN
is displayed.
HIGH MED. LOW
" opera-
" button.