Sharp compet cs-2850a Operation Manual page 2

This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
WARNING - FCC Regulations state that any unauthorized changes or modifications to this
equipment not expressly approved by the manufacturer could void the user's authority to
operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution!
The socket outlet shall be installed near the equipment and shall be easily accessible.
Aviso!
El tomacorriente debe estar instalado cerca del equipo y debe quedar bien accesible.
In case of abnormal conditions
When this unit is exposed to strong RF noise and/or extreme physical shock during
operation, or when the power cord is plugged into the AC outlet, the unit may start functioning
abnormally which, in some rare occasions, all keys cease to respond.
If such abnormal conditions are observed, unplug the AC cord from the socket. Keep the unit
unplugged for about 5 seconds, reconnect the AC plug, then turn on the power.
En caso de condiciones anormales
Si expone esta unidad a ruido de RF intenso y/o a golpes fuertes durante la operación, o
cuando enchufe el cable de alimentación en un tomacorriente de CA, la unidad puede
comenzar a funcionar de forma anormal, por lo que, en algunos casos raros, todas las teclas
pueden no ofrecer respuesta.
Si experimenta estas condiciones anormales, desenchufe el cable de alimentación de CA del
tomacorriente. Deje la unidad desenchufada durante unos 5 segundos, vuelva a enchufar el
cable de alimentación de CA, y después conecte la alimentación.