Elo Touch Solutions ET3202L User Manual page 27

In the event that a Thermal Protection Mode becomes activated, the monitor will resume full
operational capabilities only after the OSD temperature decreases below the threshold values
stated above and that temperature is retained for at least five minutes.
If Thermal Protection Mode Step 2 is reached, the internal temperature needs to first decrease
back to the Step 1 temperature and then decrease further to the value required to disable
Thermal Protection Mode 1.
Example of Thermal Protection Mode for an ET3202L Monitor with 100% Brightness in
landscape mode:
At Step 1: OSD = 58, Max Brightness = 80%
Normal operation returns if OSD can maintain 54°C or lower temperature for five
minutes.
At Step 2: OSD = 60, Brightness = 72%
Return to Step 1 if OSD can maintain 58°C or lower temperature for five minutes.
If the monitors internal temperature continues to rise, the monitor will shut off at OSD = 65°C
Table Top Mode
Requirements:
1. The Table Top Mode function on the OSD must be enabled if the unit is placed in table
top orientation.
2. Cooling methods must be put in place to ensure that the air temperature beneath the
monitor does not exceed the operating specifications. Consult chapter 7 for operating
temperature specifications.
Note: The warranty will be void if failure occurs to the monitor in table top mode orientation and
the Table Top Mode function is not enabled without adequate cooling methods installed.
User Manual: Interactive Digital Signage
SW602296 Rev A, Page 27 of 39