Function Setting - Fujitsu RCF24LBL Installation Manual

9.2. Function setting

Setting the Ceiling Height
• Select the setting values in the table below according to
the height of the ceiling. (The setting value is factory-set to
"00".)
Setting Description Function Number
Standard
(2.7 m)
High ceiling
(3.0 m)
The ceiling height values are for the 4-way outlet.
Do not change this setting in the 3-way outlet mode.
Setting the Outlet Directions
• Select the setting values in the table below for using a 3-way
outlet. (The setting value is factory-set to "00".)
Setting Description Function Number
4-way
3-way
Setting the Filter Sign
• The indoor unit has a sign to inform the user that it is time to
clean the fi lter.
• Select the time setting for the fi lter sign display interval in the
table below according to the amount of dust or debris in the
room. (The setting value is factory-set to "00".)
• If you do not wish the fi lter sign to be displayed, select the
setting value for "No indication".
Setting Description Function Number
Standard
(2,500 hours)
Long interval
(4,400 hours)
Short interval
(1,250 hours)
No indication
Setting the Cooler Room Temperature Correction
• Depending on the installed environment, the room tempera-
ture sensor may require a correction. The settings may be
selected as shown in the table below. (The setting value is
factory-set to "00".)
Setting Description Function Number
Standard
Lower control
Setting the Heater Room Temperature Correction
• Depending on the installed environment, the room tempera-
ture sensor may require a correction. The settings may be
changed as shown in the table below. (The setting value is
factory-set to "00".)
Setting Description Function Number
Standard
Lower control
Slightly warmer control
Warmer control
En-14
Setting Value
00
20
01
Setting Value
00
22
01
Setting Value
00
01
11
02
03
Setting Value
00
30
01
Setting Value
00
01
31
02
03
Setting Other Functions
• The following settings are also possible, depending on the
operating conditions. (The setting value is factory-set to
"00".)
• Auto Restart
Setting Description Function Number
Yes
40
No
• Indoor Room Temperature Sensor Switching Function
(Wired remote controller only)
Setting Description Function Number
No
42
Yes
• If setting value is "00", room temperature is controlled by
the indoor unit temperature sensor.
• If setting value is "01", room temperature is controlled by
either indoor unit temperature sensor or remote control
unit sensor.
Setting record
• Record any changes to the settings in the following table.
Setting
Ceiling height
Outlet directions
Filter sign
Cooler room temperature
correction
Heater room temperature
correction
Auto restart
Indoor room temperature
sensor switching function
After completing the FUNCTION SETTING, be sure to turn off
the power and turn it on again.
Setting Value
00
01
Setting Value
00
01
Setting Value