Installing The Remote Control Unit Holder; Decoration Panel Installation; Remove The Intake Grille - Fujitsu RCF24LBL Installation Manual

7.2. Installing the remote control unit holder

CAUTION
• Check that the indoor unit correctly receives the signal
from the remote control unit, then install the remote
control unit holder.
• Select the remote control unit holder selection site by
paying careful attention to the following: Avoid places in
direct sunlight. Select a place that will not be affected by
the heat from a stove, etc.
• Install the remote control unit with a distance of 7 m be-
tween the remote control unit and the photocell as the
criteria. However, when installing the remote control unit,
check that it operates positively.
• Install the remote control unit holder to a wall, pillar, etc.,
with the tapping screw.
(1) Mount the holder.
Screws
(2) Set the remote control unit.
Insert
Press in
(3) To remove the remote control unit (when use at hand).
Slide up
Pull out

8. DECORATION PANEL INSTALLATION

• Installation according to the Installation instruction sheet
Decoration panel.
• Be sure to confi rm there is no gap between the panel and
main unit after installing the Decoration panel.

8.1. Remove the intake grille

(1) Slide the 2 grille hook.
Grille hook
(2) Open the intake grille and remove.
En-11