Installing The Panel To Indoor Unit; Attaching The Intake Grille - Fujitsu Rcf24Lbl Installation Manual

8.2. Installing the panel to indoor unit

(1) Install the decoration panel on the indoor unit.
"DRAIN" mark
• Align the stamped marks on the decoration panel against
the pipe and the drain of the indoor unit.
CAUTION
• Use only the supplied screws to install the decoration
panel.
Indoor unit
Sealant
Decoration panel
En-12
"PIPE" mark
Screw
Ceiling
No gap between ceiling and
decoration panel around entire
periphery
(2) Connect the connector.
Wire (display): WHITE
Wire (louver): WHITE
• Arrange the wires as illustrated below.
(3) Attach the connector cover.
Screw
8.3. Attach the intake grille
The installation is the reverse of "REMOVING THE INTAKE
GRILLE".
The intake grille can be rotated and installed 4 ways to suit
the user's preference.
CAUTION
• The louver angle cannot be changed if the power is not
on. (If moved by hand, it may be damaged.)
• The grille assembly is directionally relative to the air
conditioner body.
• Install so that there is no gap between the grille assem-
bly and the air conditioner body.
• The decoration panel equips with an accessory to
prevent the grill completely open. Be sure to read the
INSTALLATION SHEET included with the decoration
panel before installation.
Wire (louver): RED
Indoor unit side
Connector cover