Connecting A Usb Storage Device; Connecting The Aerial - Currys Essentials C16LDVB11 Instruction Manual

Connecting.a.USB.Storage.Device
1.. Switch off the TV before connecting any USB storage
device.
2.. Connect your USB storage device to the USB port of
your TV.
3.. Press the. button on the right side panel of the TV
or on the remote control to turn on your TV and your
USB storage device.
4.. Press the button on the right side panel of the TV
or on the remote control to display the Input.Source.
List. Use the buttons to select DMP and then
press the OK button to confirm.
• If a hard disk is used, make sure its mains adapter is connected to the mains supply.
• If a USB hub is used, make sure its mains adapter is connected to the mains supply as the total current consumption
may exceed 500mA.
• The maximum supported storage space of the hard disk is 250 GB.
• The file system only supports FAT32 format.
• If you want to store the video streaming of a DTV programme, the transfer rate of the USB storage device must not be
less than 5MB/s, otherwise the picture and sound of the programme will be affected and a warning statement will be
shown on the screen. If this happens, please upgrade your USB storage device.
• The TV screen will be blank temporarily as it will take time to start up and stabilise the connected hard disk. This is
normal and the starting time may vary depending on the brand and the memory size of the connected hard disk.
• Disconnect the USB storage device if it is not in use.
Connecting.the.Aerial
Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the RF (75Ω) socket at the rear right side of your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
C16LDVB11_IB_110404_Annie.indd 15
Rear Right Side View of TV
USB
HDMI1 PC AUDIO
USB
USB Cable
(not included)
USB Hub
Adapter
Portable
hard Disk
USB
HDMI1 PC AUDIO
SCART
SCART VGA RF
OR
RF coaxial cable
(not included)
VGA RF
15
GB
11年4月4日 下午6:04