Table of Contents
Advertisement
Available languages
Available languages
EURO • Printed in England • GB • F016 L69 838 • CLUB/ROYALE • OSW 08/01
CLUB/ROYALE - Buch Seite 3 Dienstag, 7. August 2001 2:41 14
3. Add a good-quality SAE 30 API SF in small quanti-
ties at a time, allowing it to settle. Repeatedly add
oil and check the level until it reaches the dip
stick
9
. The engine may require up to 0.6 litres of
oil.
4. Refit and tighten the oil filler dip stick
C
D
Petrol
Petrol deteriorates over time. Engine starting
may be difficult if you use petrol kept for more
than 30 days. Always run the fuel tank dry when
storing over 30 days.
1. Remove the petrol filler cap
to the tank, leaving approximately 6 mm of tank
space for fuel expansion.
2. Replace the petrol filler cap
3. Wipe up any spilt petrol from the engine before
starting the mower.
Battery (Electric start models)
The battery is already connected. For charging see
chapter "Battery".
C
D
Grassbox/bag
Attach/remove the grassbox as shown.
Height of cut adjustment
E
Club B20
Your mower has an adjustable height of cut between
2,8 – 18 mm.
The height of cut adjusted as follows:
1. Slacken bolts
on both sides of the mower.
10
2. Turn the height of cut knob
quired height of cut.
3. Tighten bolts
.
10
F
G
Royale models
Your mower has an adjustable height of cut between
5 – 35 mm with markings spaced between as an aid
to adjustment.
Adjusting the Cutting Height
Tilt the mower back and pull plunger
the stand
to extend fully.
12
1. Carefully release the plunger
home and rest the mower on the stand
2. Slacken bolts
on both sides of the mower.
13
3. Turn the height of cut knob
quired height of cut and tighten bolts
4. Tilt the mower back and pull plunger
5. Raise the mower stand
12
plunger
.
11
Note: For all models you may need to re-adjust the
comb after changing height of cut (see "Comb Adjust-
ment" below).
15 • F016 L69 838 • TMS • 11.07.01
9
.
5
, add unleaded petrol
.
5
8
to achieve the re-
11
, allowing
11
ensuring it is fully
.
12
8
to achieve the re-
.
13
fully.
11
and carefully release the
English - 3
Comb Adjustment
Your mower has an adjustable comb fitted which can
be brought into use on the lower heights of cut.
The comb is adjusted as follows:
E
Club models
1. Slacken nuts
.
14
2. Turn screws
until the comb tines just touch the
15
ground.
Note: Take care not to set the comb tines too deep.
3. While holding screw
tighten nuts
15
comb in place.
F
G
Royale models
1. Slacken nut
16
and screws
just touch the ground.
Note: Take care not to set the comb tines too deep.
2. While holding nut
16
tighten screws
comb in place.
Using Your mower
Starting and Stopping
Starting from Cold
Recoil Start Models:
1. Move the engine cut-off switch
2. Move the throttle lever
19
3. Turn the petrol tap
20
on.
4. Move the choke lever
21
5. Pull the recoil cord handle
handle to return slowly after each pull.
Electric start models:
1. Move the engine cut-off switch
2. Move the throttle lever
19
3. Turn the petrol tap
on.
20
4. Move the choke lever
21
5. Turn the key clockwise to start. If the engine
doesn't start after three attempts use the recoil cord
handle and charge the battery (see maintenance
and also fault finding sections).
Starting from Hot
Follow "Starting from Cold" ignore steps 4 only.
If the engine does not start or will not continue to run
follow the "Starting from Cold" procedure with choke
lever between the "On" and "Off" postion.
Stopping
1. Move the throttle lever
ping.
H
2. Move the engine cut-off switch
to lock the
14
17
until the comb tines
17
to lock the
I
to ON.
18
H
to position
.
I
to "On".
. Allow the recoil
22
I
to ON.
18
H
to position
.
I
to "On".
to position Stop-
19
I
to OFF.
18
Hide quick links:
Advertisement
Table of Contents
