TOTALINE 1 For All Owner's Manual page 26

About Advanced Features & Operation
REMOTE SENSORS (Optional Accessory) - When connected to
thermostat terminals RS+5, RS, & GND
temperature from the remote sensor and ignore the temperature sensor
inside the thermostat. The thermostat is programmed from the factory
to automatically recognize
#16, page 17). When the thermostat is programmed to read
temperature from the remote sensor, the degree
temperature will blink once a second.
OVER
RIDE
OVER
RIDE
Optional
Remote Sensor
Optional RF Sensor thermostat does.
set the runtime to maximum setting (4:00). The Locked feature has no
effect on the remote OVERRIDE button. The wired sensor can be
connected to the thermostat with up to 150' of 18 ga., 300' of 20 ga.,
or 450' of 22 ga. Unshielded, thermostat wire.
This wire MUST be completely separated from the thermostat
or any other control wiring and must NOT be in the same
conduit as high voltage wiring.
C
G
Y1
W1-O-B
R
See the Remote Sensor instructions for further details.
, the thermostat
when a Remote Sensor is connected (step
icon
The Override button on the remote sensor works
slightly different than the Override button on the
front panel of the thermostat. Each press of the
remote OVERRIDE button adds 2 hours to the
override timer. If the timer was already active, the
first button press will round the runtime to either
2:00 or 4:00. Subsequent button presses will not
wraparound as the Override button on the
Instead, every subsequent button press will
CK1
GND
RS
RS+5
W2
Y2
Page 25
will read the
the
above the room
RS-GND
RS
RS+5