Makita 4324 Instruction Manual page 9

Loosen the bolt on the back of the tool
I
base with the hex wrench. Move the tool
base so that the bolt is positioned in the
center of the cross-shaped slot in the tool
base.
Tilt the tool base until the desired bevel
angle is obtained. The edge of the motor
housing indicates the bevel angle. Check
the contact between the back edge of the
blade and the roller, then tighten the bolt to
secure the tool base.
Front flush cuts
Loosen the bolt on the back of the tool
base with the hex wrench, then move the
tool base all the way back. Then tighten the
bolt to secure the tool base.
1 - 7
Hex wrench
A
Indicate
9