Makita 4324 Instruction Manual page 5

Installing or removing
the
saw blade
CAUTION:
*Always be sure that the tool is switched off and unplugged before installing or removing
the blade.
*Always clean out all chips or foreign matter adhering to the blade and/or blade holder.
Failure to do so may cause insufficient tightening of the blade, resulting in a serious injury.
To install the blade, loosen the bolt on the
blade holder with the hex wrench.
With the blade teeth facing forward, insert
the blade into the blade holder as far as it
will go. Make sure that the back edge of the
blade fits into the roller. Then tighten the
bolt to secure the blade.
To remove the blade, follow the installation
procedures in revers.
NOTE:
Occasionally lubricate the roller
5