Advertisement
Remove all packaging before positioning the
machine.
See the following diagram.Ensure there is a
clearance each side of the machine to allow
600mm
slight side ways movement for servicing
Work top of your dishwasher is removable
if required. Height without the work top is
820 mm.
By removing the machine's worktop,you can
install it under a close fitting sink unit or a
pre-existing top,if the dimensions of the
recess correspond to those shown in the
picture.
To remove the worktop;remove two screws
as shown at the rear of the worktop on either
side,lift up the rear section, push forward
to release off the lug at the front section of
the appliance and lift up.
Remove the polystyrene block and if you wish
save for future re-use.
Position the machine next to a water tap and
a drain.
When inserting the maching, ensure that the
water inlet and drain hoses are not kinked or
squashed.
Care must be taken to ensure that the
appliance does not stand on the electrical
supply cable.
Good levelling is essential for correct closure
and sealing of the door.
When the appliance is correctly levelled,the
door will not catch on the inner liner on either
side of the cabinet.
If the door does not close correctly, loosen
or tighten the adjustable feet, until the
machine is perfectly level.
2
Advertisement
