Download  Print this page

Kenwood KDW12SL3A Instruction Manual page 14

Hide thumbs

Advertisement

'
Fuse blown, or the
circuit breaker acted
Power supply is not
turned on
Water pressure is low
'
Overflow
Some audible sounds are
normal
Utensils are not secure
in the baskets or something
small has dropped into
the basket
Motor hums
Improper detergent
Spilled rinse agent
Detergent with
colorant was used
Rinse agent dispenser
is empty
Improper program
Improper rack loading
Extremely hard water
Low inlet
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Empty rinse agent
dispenser
Incorrect dosage of
detergent
12
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher
Make sure the dishwasher is turned on and the door is
closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Check that the water supply is connected properly and
the water is turned on.
The system is designed to detect an overflow. When it
does, it shuts off the circulation pump and turns on the
drain pump. Service required.
Sound from soft food shredding action and detergent cup
opening.
Ensure everything is secured in the dishwasher.
Dishwasher has not been used regularly. If you do not use it
often, remember to set it to fill and pump out every week,
which will help keep the seal moist.
Use only the special dishwasher detergent to avoid suds.
If this occurs, open the dishwasher and let suds evaporate.
Add 1 gallon of cold water to the tub. Close and latch the
dishwasher, then drain out the water by starting a program
but stopping it before it finishes. Repeat if necessary.
Always wipe up rinse agent
spills immediately.
Make sure that the detergent has no colorant.
Make sure that the rinse agent dispense is filled.
Select stronger program
Make sure that the action of the detergent dispenser and
spray arms are not blocked by large dishware.
To remove spots from glassware:
Take out all metal utensils out of the dishwasher.
Do not add detergent.
Choose the longest cycle.
Start the dishwasher and allow it to run for about
18 to 22 minutes, then it will be in the main wash.
Open the door to pour 2 cups of white vinegar
into the bottom of the dishwasher.
Close the door and let the dishwasher complete
the cycle. If the vinegar does not work: Repeat
as above, except use 1/4 cup (60 ml)of citric acid
crystals instead of vinegar.

Advertisement

Table of Contents
loading

  Also See for Kenwood KDW12SL3A