Table of Contents
Advertisement
TG8411NZ(e).book Page 38 Thursday, March 26, 2009 3:27 PM
Useful Information
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Cause/solution
L The supplied telephone line cord has not been
Check Phone Line
L Phonebook copy failed (page 20). Confirm the other
Failed
L The receiver's phonebook memory is full. Erase the
Incomplete
L The phonebook memory is full. Erase unnecessary
Memory Full
L The call barred list memory is full. Erase unnecessary
L The maximum number of base units (4) is already
L The handset has lost communication with the base
No link.
Reconnect AC
adaptor.
L Unplug the base unit's AC adaptor to reset the unit.
L The handset's registration may have been cancelled.
L A wrong type of battery such as Alkaline or
Use rechargeable
battery.
L You must subscribe to a Caller ID service. Once you
You must first
subscribe to
Caller ID.
38
connected yet or not connected properly. Check the
connections (page 9).
handset (the receiver) is in standby mode and try
again.
unnecessary phonebook entries from the other
handset (the receiver) and try again.
entries (page 19).
entries (page 27).
registered to the handset. Cancel unused base unit
registrations from the handset (page 29).
unit. Move closer to the base unit and try again.
Reconnect the adaptor and try again.
Re-register the handset (page 28).
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 3, 6.
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Advertisement
Table of Contents
