P [Protect] - Panasonic Lumix DMC-FS5 Operating Instructions Manual

Advanced (Playback)
•
It may not be possible to use the DPOF print settings with other equipment. In this case, cancel
all the settings, and reset the settings.
•
If the file is not based on the DCF standard, the DPOF print setting cannot be set.
You can set protection for pictures you do not want to be deleted by mistake.
1
Select [PROTECT] on the [PLAYBACK] mode menu. (P19)
2
Press 3/4 to select [SINGLE] or [MULTI] and then
press [MENU/SET].
3
Select the picture, and then press
[MENU/SET].
When [MULTI] has been selected
•
Repeat these steps for each picture.
•
The settings are cancelled when [MENU/
SET] is pressed again.
4
Press [‚] to return to the menu screen.
•
Press [MENU/SET] to close the menu.
∫ Cancelling all the [PROTECT] settings
1
Select [CANCEL] on the screen shown in step
2
Press 3 to select [YES] and then press [MENU/SET].
3
Press [MENU/SET] to close the menu.
•
If you press [MENU/SET] while cancelling protection, the cancelling will stop halfway.
Note
•
The protect setting may not be effective on other equipment.
•
Even if you protect pictures in the built-in memory or a card, they will be deleted if the built-in
memory or the card is formatted.
•
Even if you do not protect pictures on an SD Memory Card or an SDHC Memory Card, they
cannot be deleted when the card's Write-Protect switch is set to [LOCK].
82
VQT1N09

P [PROTECT]

[SINGLE]
Press 2/1 to
select the picture.
2
Press 3/4/2/1
to select the
pictures.
and then press [MENU/SET].
[MULTI]