Yamaha AV-1 Owner's Manual page 33

ENJOYING LISTENING TO A SOURCE
TRACK PRESET
PRO LOGIC DSP OFF
ENHANCED MONO MOVIE
ROCK CONCERT VIDEO
DISCO HALL STADIUM
/
OPEN/CLOSE CD TUNER TAPE/MD VCR
3
VIDEO 2
PUSH
PHONES
POWER
MINI COMPONENT SYSTEM AV–1
TUNER
CD
CENTER/REAR
/DELAY
C/R/D
ON/OFF DSP
TEST
SLEEP
POWER AMP
3
PHONES
PUSH
PHONES
POWER
TIMER SLEEP
F REP AUTO ST
Hz MEMORY
K
MHz PTY HOLD
VIDEO 1 VIDEO 2 VOLUME
2
MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
TIME ADJ TIMER
/ / REPEAT
HOUR MIN
OPEN/CLOSE
PRESET
LEVEL
PROGRAM
SUBWOOFER
SUBWOOFER
– / +
INPUT
2
VOLUME
MEMORY AUTO/MAN'L PRESET/BAND DISPLAY
VIDEO 2
TIME ADJ TIMER
/ /
REPEAT
HOUR MIN
MINI COMPONENT SYSTEM AV–1 OPEN/CLOSE
To finish listening to a source
1
Stop playing a source.
2
Press the VOLUME "
the volume to minimum until "MIN" is shown on the
display.
3
Press the POWER switch to turn this system into the
standby mode.
* In this mode, only the time is shown on the
display.
Adjusting the subwoofer output level
According as you prefer, adjust the subwoofer output
level by pressing the SUBWOOFER level + (up) or –
(down) button.
If you feel that bass tone is insufficient, increase the
level, and if you feel that bass tone is overly
emphasized, decrease the level.
Listening with headphones
● Be sure that your headphones have a 3.5 mm (1/8")
diameter plug and are between 16 ohms and 50
ohms impedance. Recommended impedance is 32
ohms.
●
When you listen with headphones, connect the
headphones to the PHONES jack. You can listen to
the sound to be output from the front speakers
through headphones.
When listening with headphones privately, switch off
C
the digital sound field processor (so that no DSP
program name is illuminated on the display) by
pressing the DSP ON/OFF button on the remote
control transmitter. Adjust the VOLUME buttons for
desired volume.
E-29
" (or "–") button to decrease