Electrical Connections - Quorum The Alton Installation Instructions Manual

5. ELECTRICAL CONNECTIONS

REMEMBER -Turn off the power!
Use the wire nuts supplied with your fan
when making connections. Secure the
connectors with electrical tape and make
sure there are no loose connections or wire
strands.
1. Find the DIP switches located on the
side of the receiver unit. Set the switches
at random to set the frequency at which the
unit will operate. At least one of the four
switches must be in the "ON" position.
2. Make wire connections from the fan
to the wall control receiver unit. For this
step use the bundle of 3 wires on the
receiver. (Fig. 8)
Connect the BLACK fan wire to the
BLACK receiver wire.
Connect the BLUE fan wire to the
BLUE receiver wire.
Connect the WHITE fan neutral wire
to the WHITE receiver neutral wire.
3. Connect the wiring from the ceiling to
the receiver unit. (Use the 2 wire bundle
on the receiver.) Secure with supplied wire
nuts.
Connect the BLACK building
supply wire to the BLACK receiver
wire.
Connect the WHITE receiver neutral
wire to the WHITE building neutral wire.
Connect the COPPER building
ground wire to the GREEN fan ground
wire.
4. Connect the wiring from the wall
switch receptacle to wall transmitter unit.
Remove the existing wall plate and
switch from the wall junction box.
Connect one BLACK wire from the
wall to one BLACK wire (labeled "TO
FAN") from the wall transmitter.
Connect the other BLACK wire (labeled
"TO POWER SUPPLY") from the
transmitter to the remaining BLACK wire
from the wall (A/C supply source).
If your junction box has a ground wire
(green or bare copper), connect the
transmitter's ground wire to it. Otherwise,
connect the transmitter ground wire
directly to one of the screws from the
outlet box.
Find the DIP switches located on side of
the wall control unit. Ensure the setting
matches the switch setting on the receiver.
Carefully tuck the connected wires
inside the junction box. Secure the
transmitter with the two screws provided.
Attach the face plate over the transmitter
with the two screws provided.
Fig. 8
House
supply
wire
HI
LIGHT
MED
LOW
FAN OFF
ON
OFF
Wall control
NOTE: It may be necessary to bind
the house wires to the corresponding
receiver wires with electrical tape
before capping them with wire nuts.
This will prevent them from slipping
apart during the rest of the installation.
5. The wall control and receiver unit has
16 different code combinations.
Your fan will not operate if the switch
settings do not match.
If you have another remote operated fan in
your home, make sure its combination of
switch settings are different from those of
your new fan.
6. Put the receiver unit inside the canopy.
Proceed to Step 6 - Completing the
Installation.
BLK
ON
Outlet box
Ceiling
Receiver
GRN
Fan canopy