Setting The Height Of The Armrests; Adjusting The Width Of The Armrests - Invacare Storm4 X-plore User Manual

Invacare® Storm®⁴ Series
1. To change the position of the arm support, loosen the screw
(1) and remove it.
2. The position of the arm support is adjusted by selecting a
combination of screw holes in the arm support and the drill
holes in the fixing plate.
3. Reposition the screws and tighten.

5.3.2 Setting the height of the armrests

Tools:
•
3 mm Allen key
Unscrew screw A with Allen key.
1.
2. Adjust armrest to required height.
3. Retighten the screw.
30

5.3.3 Adjusting the width of the armrests

WARNING!
Serious injury hazard if one of the armrests
falls out of its bracket because they have been
adjusted to a width which exceeds the permissible
value
– The width adjustment is fitted with small stickers with
markings and the word "STOP". The armrests must
never be pulled out further than the point at which
the word "STOP" is completely legible!
– Always tighten the fixing screws properly once
adjustments have been completed.
Tools:
•
8 mm Allen key
1. Loosen screw (1).
2. Adjust armrest to required position.
3. Retighten the screw.
4. Repeat this procedure for the second armrest.
1529686-R