Table of Contents
Advertisement
61 To replace the cover, locate the lugs on the right of the cover in the slots in the rear of the
cleaner.
62 Fit the cover into the rear of the cleaner, and press the tab till it clicks into place in the lock.
cleaning the cleaner
63 Switch the cleaner off and unplug it before cleaning.
64 Don't put any part of the cleaner in a dishwasher.
65 Don't use harsh or abrasive cleaning agents or solvents.
66 Wipe external surfaces of the cleaner with a damp cloth.
67 Wipe the tools and tubes with a damp cloth.
68 A dab of washing-up liquid will remove stubborn stains, but clean it off afterwards, or it may
stain.
timing
69 Clean the cleaner frequently. Basically, the better you look after it, the longer it'll last. Keep an
eye on it as you use it, and examine the filters when you empty the bin. If anything needs
cleaning, do it there and then, don't put it off, in case you forget.
blockages
70 No matter how careful you are, sooner or later you'll block the cleaner.
don't panic!
If the cleaner starts to get noisy and you start to lose suction, don't worry, it's not the end of the
world, you've probably just blocked it up.
1 Switch the cleaner off and unplug it.
2 Spread a newspaper on the floor, you're going to make a mess.
3 If you're using one of the tools, remove and check it first.
4 Turn the turbo brush over, press the tab, and remove the door, to check the turbo.
5 Pull the hose out and check it.
6 Use something blunt, like the blunt end of a ball-point pen to dislodge any blockage.
7 Remove the bin, and check the HEPA filter, foam filter, and plastic filter.
8 If you haven't cleared the blockage by now, try again.
9 Still not clear? – Ring the helpline.
7
Advertisement
Table of Contents
