Making A Call To The Pstn In Standby Mode - D-Link DPH-300 User Manual

DPH-300 User's Manual

Making a Call to the PSTN in Standby Mode

If you have connected your PSTN telephone line to the DPH-300's Base, you can
make a telephone call to any regular telephone using the PSTN by following these
steps:
Pick up the handset and dial the number as you normally would. You can clear any
or all of the numbers you have entered by pressing the Clear button. You will hear
the familiar PSTN dial tone, the handset and L1 icon will appear in the handset's
LCD display.
This number will be dialed as you enter it.
To end the call, either press the On Hook button or replace the handset on the
charger.
PSTN Dial Tone
Press this button
to dial a
telephone
number (over the
regular telephone
line (PSTN)).
You will hear the
familiar dial tone
− and then the
handset will dial
the telephone
number as you
entered it.
Keypad
You can just
dial a regular
telephone
number and
then press the
PSTN Dial
Tone button.
The number
will be
displayed in
the LCD.
56
Making Phone Calls
On Hook
Press this
button to end
a telephone
call. You can
also simply
place the
handset in the
charger base
to end any
telephone call.
This will end
both a PSTN
and a VoIP
telephone call.
Clear
Press this button
to erase a single
digit of a telephone
number you have
entered while the
handset is in
Standby Mode.
Holding this button
for a couple of
seconds will erase
all of the digits of
the telephone
number
D-Link Corporation