Settings; Dashboard; Camera Settings - Blackmagicdesign Blackmagic URSA Installation And Operation Manual

Settings

Dashboard

On Blackmagic URSA press the 'display' button marked DISP on the control panel to open the
dashboard. On URSA Mini press the 'menu' button. From the dashboard you can open the
settings menu and change settings. You can also tap on icons to hide or show meters and
guides on the LCD monitor, or format your CFast cards. On URSA Mini the dashboard can also
be used to access the metadata settings, or you can easily bypass the dashboard and go
straight to the menu settings on URSA Mini by pressing and holding the 'menu' button.
Press the 'disp' button below a touchscreen to open the dashboard.

Camera Settings

To configure camera settings on your Blackmagic URSA or URSA Mini, select the 'camera'
touchscreen menu, then tap the relevant arrows and icons with your finger.
To configure camera settings on your Blackmagic
URSA, select the 'camera' touchscreen menu.
Camera ID
If using more than one Blackmagic URSA or URSA Mini, it's helpful to set each camera's ID
which will be included with any metadata recorded with your clips. Set the 'camera ID' with the
touchscreen keyboard. Select 'enter' to save your camera ID, or 'cancel' to discard
any changes.
ATEM Camera ID
If you're using URSA Mini with an ATEM Switcher and want your camera to receive tally signals
from the switcher, you'll need to set the camera number on your camera. This ensures the
switcher sends the tally signal to the correct camera. The camera number can be set to a value
of 1-99. The default setting is 1.
Settings 38