Server Lockout; Service Tools - Bunn SINGLE SHDBC Installation & Operating Manual

PROGRAMMING FUNCTIONS - (cont.)
SERVER DETECT
This function allows the operator to prevent the start
of a brew cycle if a Soft Heat server is not positioned
correctly on the brewer.
SERVER DETECT ?
NO DONE
Procedures to set server detect:
1. Press and hold upper right hidden switch until the
display reads SET NEW RECIPES. Release switch.
Press and release upper right hidden switch until
the display reads SERVER DETECT.
2. The NO or YES fl ashes to indicate the current
selection.
3. Select YES to prevent brewing if the Soft Heat
server is not correctly positioned on the brewer
beneath the funnel.
NOTE: If YES is selected and a brew cycle is attempted
with a server not properly placed, the display will read
SERVER NOT IN PLACE.
4. Select NO to allow brewing without a Soft Heat
server in place. This is selected when brewing into
a container other than a Soft Heat Server.
5. When fi nished, press and release DONE. This will
save the new setting, exit the function screen and
advance to SERVICE TOOLS. Another alternative
is to press the pad located on the front switch
panel to exit the SERVER DETECT function and
return to the MAIN SCREEN.
YES
P2310
NEXT FUNCTION
Page 23

SERVICE TOOLS

This function allows the testing of individual com-
ponents and the ability to check switches for proper
function. This function also tests the Soft Heat server's
status on the brewer (in place or removed), and the
funnel sensor coil's frequency (diagnostic tool for
troubleshooting purposes only).
SERVICE TOOLS?
NO
EXIT TO
NEXT FUNCTION
SCREEN
TEST OUTPUTS?
NO
TEST SWITCHES?
NO YES
NOTHING PRESSED
TEST SERVERS?
NO YES
TEST FREQUENCY?
NO YES
EXIT TO
SCREEN
YES
YES
PRESS AND RELEASE
UPPER
® SYMBOL RIGHT HIDDEN SWITCH
BREW VALVE
ON NEXT
NEXT COMPONENT
TO BE TESTED
SERVER REMOVED
IN PLACE
PRESS AND RELEASE
® SYMBOL
UPPER RIGHT
HIDDEN SWITCH
125.0 KHZ. 4
4 125.0 KHZ.
PRESS AND RELEASE
UPPER RIGHT ® SYMBOL
HIDDEN SWITCH
P2449
34025.1 011006
OFF