Table of Contents
Advertisement
Install the supplied tool rest locking lever on to the
tool rest extension post and set the post aside for
use during outboard turning.
BASIC ADJUSTMENTS & CONTROLS
ON /OFF POWER SWITCH:
The wood lathe is equipped with a rocker type ON/OFF switch located on the headstock A, that is equipped with a lock-out key.
To prevent unwanted or unauthorized start-up or usage remove the lock-out key and store it in a safe place B.
To start the lathe, insert the lock-out key and pull up the switch C.To stop the lathe, push down on the power switch D.
A
FORWARD / REVERSE SWITCH
ALWAYS BE SURE TO STOP THE LATHE SPINDLE COMPLETELY BEFORE CHANGING DIRECTION. WHEN MOUNTING A FACE PLATE,
ALWAYS MAKE SURE THE SET SCREWS IN THE FACE PLATE ARE TIGHTENED SECURELY AFTER THE FACE PLATE IS INSTALLED. FAIL-
URE TO DO SO MAY RESULT IN THE FACE PLATE UNSCREWING FROM THE SPINDLE.
The Forward/Reverse switch E is located on the rear of the
headstock F.
Forward: The spindle rotates toward to the operator from the
top of the workpiece.
Reverse: The spindle rotates backward to the operator from
the top of the workpiece.
B
Pull UP to START
E
Press DOWN to STOP
C
D
F
9
Hide quick links:
Advertisement
Table of Contents
