General International MAXI-LATHE VS+ 25-200 Setup & Operation Manual page 11

7. To verify the belt positioning and ensure the belt
will run smooth on the pulleys; rotate the fly
wheel A by hand to turn the spindle while
observing the belt movement. If the belt moves
smoothly re-install the belt guard – if the belt
wobbles between the pulleys repeat steps 3-6 as
needed.
TOOL REST CARRIAGE & TOOL REST ADJUSTMENTS:
B
1. The tool rest carriage can be moved along the
bed slide ways as needed. Loosen the tool rest
carriage lever B and move the carriage to the
desired location. Re-tighten the lever securely
after adjustment.
MOUNTING & REMOVING HEADSTOCK SPUR CENTER:
D
1. The headstock spindle has an MT#2 taper hole
into which the spur center fits D. Make sure the
shank of the spur center and the spindle hole
are clean and free of debris, then fit the spur
center firmly in the spindle hole by hand E.
MOUNTING & REMOVING TAILSTOCK LIVE CENTER:
1. The tailstock has an MT#2 taper hole into which
the live center fits. Make sure the shank of the
live center and the tailstock hole are clean and
free of debris and fit the live center firmly in the
spindle hole by hand.
2. The tool rest should be adjusted so that its top is
1/8" above the center of the workpiece. Loosen
the tool rest locking lever C and adjust the
height and position of the tool rest as needed.
Re-tighten the lever securely after adjustment.
E
2. To remove the headstock spur center, knock it
out from the opposite end of the spindle
using the supplied knock-out-bar.
Note: When knocking out the spur center, always
hold it by hand to prevent it from falling.
A
C
11