Download  Print this page

General International MAXI-LATHE VS+ 25-200 Setup & Operation Manual Page 8

Hide thumbs

Advertisement

A
C
Release the headstock locking lever A and pull the
headstock pivot pin B outwards and pivot the
headstock 180º. Lock the headstock in place by
pulling the headstock locking lever forward C.
Install the belt tension release lever as shown.
E
Thread the face plate onto the headstock spindle
E and tighten using the supplied face plate
wrench (Insert the knock-out bar in the spindle
hole F to keep the spindle from turning while tight-
ening the face plate).
8
B
F
D
Use the 2 mounting bolts and lock washers D to
attach the outboard bed extension to the bed as
shown.
Install the tool rest on the tool rest carriage.
TOP VIEW
G
Then lock the face plate by tightening the two set
screws G using a 3 mm Allen key.
Top View
Side View

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: