Return The Extender To Its Factory Default Settings - NETGEAR WN3000RPv3 User Manual

A confirmation pop-up window opens.
9. Confirm your decision.
The extender configuration is restored and the extender restarts. This process takes
about one minute.

Return the Extender to Its Factory Default Settings

Under some circumstances (for example, if you lose track of the changes that you made to
the extender settings), you might want to erase the configuration and reset the extender to
factory default settings.
To reset the extender to factory default settings, you can either use the Factory Reset button
on the rear panel or log in to the extender and reset it.
For a list of factory default settings, see

To use the Factory Reset button to return the extender to factory default settings:
CAUTION:
This process erases any settings that you configured in the extender.
1. Insert a straightened paper clip into the hole of the Factory Reset button and hold it for
about seven seconds.
Factory Reset
button
2. Release the button.
CAUTION:
Do not try to go online, turn off the extender, shut down the computer, or
do anything else to the extender until it finishes restarting.
N300 WiF Range Extender
Factory Default Settings
Maintain and Monitor the Extender
38
on page 46.